用户名: 密码:
新用户注册
监管者: Backoff 
 Motors

Land-Sea-Air, Land on this board and Sea for yourself what is going on in the motoring world and Air your views. Also ask for advice.


每页的消息:
讨论板列表
您未权限在该板张贴消息。只有最低脑兵级别的会员才允许张贴在该板。
状态: 所有人能发表
帖子搜索:  

8. 七月 2008, 02:00:27
srnity 
题目: Need An Opinion (or two).....
To replace a rear main seal on a Dodge Neon (my kid's car) - - - got a quote for $400 (cutting me a break on labor, it's a six hour job) - - - I read somewhere, but can't remember where, that it's better to go with a red rubber seal (?) instead of the manufactured seal to avoid the same slippage problem happening again - - - anybody know if it'll make a difference? Also was told that all they have to do is disconnect (and drop) the trannie from the motor, clean the connections, and replace the seal, so that means that there's no "internal" trannie work needed, correct? And, while I'm at it - - - should I get them to do the "cam seal" while they're at it? If ya know, please let me know, I'm mostly car-stupid

9. 七月 2008, 14:53:47
Bwild 
题目: Re: Need An Opinion (or two).....

srnity: the full extent of your repair cant really be told till the tranny is out and the failed seal is pulled.  if the shaft is bad(excessive wear at the seal surface) then the price of poker just went up.


as far as the seal....if they use a quality seal...not just the' best buy' brand...and its installed properly...then there should be no problem.


you should wonder of course...what caused the seal failure to begin with. if thats not addressed...you could be out another 400.00.


just my 2 cents :o)


日期和时间
在线的朋友
最喜欢的讨论板
朋友群
每日提示
Copyright © 2002 - 2024 Filip Rachunek, 版权所有
回顶端